Driving; Switch The Transmitter And Receiver On - Reely 2390371 Bedienungsanleitung

11. Driving

Important
Please complete the steps outlined in ""10. Getting ready for driving" on page 30.".
a) Switch the transmitter and receiver ON
Important
Never reach into the drive, and do not stop the wheels with your hand.
1. Switch the transmitter ON.
- The LED will blink quickly to indicate it is waiting to connect to the receiver.
- The LED will be solid on when successfully connected.
2. Switch the receiver ON.
- Press and hold the receiver power button for approximately 3 seconds.
3. Check the following:
Do not touch the throttle lever during checking!
- HT.TRIM: The dial should be in the middle position so that the wheels are facing forward. You can fine tune the
trim later. See section "c) Adjusting trim / speed inputs" on page 34".
- If the (receiver / transmitter) link is broken, switch the transmitter power on, and within 3 seconds switch the
receiver power on.
4. Replace the car body.
5. The car is now ready for driving.
32