Releasing The Brake - Ottobock Xeno Gebrauchsanweisung

NOTICE
Risk of damage when parking the wheelchair with the
brake deactivated. Releasing the brake may result in un-
controlled rolling of the power wheelchair. Therefore, en-
sure that the brake is engaged after parking the power
wheelchair.
It is possible to push the power wheelchair in case of control
unit failure or insufficient battery charge level. To do so, the
brake is deactivated via the mechanical release. The brake
release mechanism is located on the right between the
frame and seat.

Releasing the brake

For reasons of safety you must first pull up the brake release
bolt.
INFORMATION
When in this position, the brake must still be engaged!
Should the brake already be released and the pushing
function be active at this stage, please contact your
wheelchair supplier.
Xeno
Downloaded from www.Manualslib.com manuals search engine
INFORMATION
When the joystick is activated while the brakes are un-
locked, the control system emits an error signal on the con-
trol panel. If this is not the case, there is a malfunction that
must be corrected immediately by a specialist dealer.
1
Fig. 26 Releasing the brake
1 Brake release bolt
Operation
2
2 Brake release lever
Ottobock 167
|