Supports (Optional); On The Seat - Ottobock Xeno Gebrauchsanweisung

Changing the position
To adapt the armrest to the forearm length of the user, the
screw connections on the underside of the armrest have to
be changed:
1. Loosen the two screws on the underside of the armrest.
2. Move the armrest with the control panel receiver or the
replacement tube along the attachment rail forwards or
backwards into the desired position.
3. Fimly retighten the two screws.
Fig. 10 Changing the armrest position
Xeno
Downloaded from www.Manualslib.com manuals search engine

6.1.4 Supports (optional)

Changing the position of the supports on the seat
There are receivers for a support on the right and left side of
the seat frame. The receivers can be attached over the en-
tire seat depth range. Several slot holes are provided in the
seat frame for this purpose. To change the position of the
supports on the seat proceed as follows:
1. Loosen the two screws on the seat frame.
2. Move the receiver on the seat frame along the slot hole
forwards or backwards or select another slot hole for
attachment.
3. Fimly retighten the two screws.
Fig. 11 Changing the position of the support on the seat
Operation
Ottobock 147
|