Creep Speed - Control Panel Display/Lcd Display - Ottobock Xeno Gebrauchsanweisung

NOTICE
Risk of damage due to improper maintenance. Inspect
the stand-up device for visible signs of damage at least
once a month and ensure all screw connections are tight.
Also maintain correct air pressure in the tyres.
NOTICE
Risk of damage during transportation. Always lower the
stand-up device fully for loading or transportation.
INFORMATION
For optimal operation of the stand-up function, please
also observe the instructions in the brochure "Richtig Ste-
hen" (correct standing).
INFORMATION
Make sure a sufficient supply of power is maintained in or-
der to guarantee proper operation of the stand-up device.
INFORMATION
Please also observe the safety instructions in the section
"Electric Seat Functions" > "Safety Instructions".
The power wheelchair is equipped with a stand-up device
that enables the user to assume a standing position (see
Xeno
Downloaded from www.Manualslib.com manuals search engine
fig. 29). The joystick in the "additional functions" mode is
used to control this function (see section 6.3.6).
The driving function at home remains available even when
the seat is raised to the standing position. As soon as the
seat leaves the lowest position, the speed is reduced (creep
speed) because the power wheelchair is less tip-resistant.
This is indicated by a snail symbol on the control panel or
the optional, separate LCD monitor.
Fig. 28 Creep speed – control panel display/LCD display
Operation
Ottobock 175
|