Knee Pad; Changing The Chest Belt Height - Ottobock Xeno Gebrauchsanweisung

Operation
Changing the height of the chest belt
The chest belt is attached to the top of the backrest. The height
can be adapted to the user requirements by changing the
mounting position in the slot holes. It is also possible to mount
the chest belt at the same height as the support by positioning
and mounting the belt holder under the support holder.
1. Loosen the two Allen head screws of the holder (4 mm
Allen wrench) on the right and left of the backrest.
2. Move the holder in the slot holes.
3. Firmly retighten the screws.
2
Fig. 18

Changing the chest belt height

1 Chest belt holder
2 Support holder
152 | Ottobock
Downloaded from www.Manualslib.com
1
manuals search engine

6.1.8 Knee pad

WARNING
Risk of accident and injury due to improper use of the
standing function. The standing function may only be
used with the chest belt, lap belt and knee pad applied.
Applying the knee pad
1. Attach the eyelets of the knee pad belt to the two belt
knobs.
2. Ensure that the knee pad lies flat on the lower leg below
the kneecap.
3. Secure the knee pad by tightening the belt.
4. Tighten the belt with the belt tensioner. Ensure that it
snaps into place audibly.
Opening the knee pad
Loosen the belt tensioner.
Xeno