Getting Into And Out Of The Power Wheelchair; Affixing The Control Panel - Ottobock Xeno Gebrauchsanweisung

Operation
Fig. 20

Affixing the control panel

Firmly re-tighten the screws after making adjustments.
INFORMATION
If the control panel rail is too long, the protruding part can
be cut off with a saw.
Mounting and removing the control panel
The standard configuration has the control panel mounted
on the right side. Depending on whether the wheelchair user
is a right hander or left hander, it can be mounted to either
armrest, which is to be done by a specialist dealer.
154 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
6.2

Getting into and out of the power wheelchair

CAUTION
Risk of injury if the power wheelchair starts rolling.
Switch off the wheelchair control before getting into and
out of the power wheelchair. This will automatically en-
gage the motor brake.
CAUTION
Risk of pinching or crushing in the pivot ranges of the
armrests and footplate. When swinging the armrests up
or down and when flipping the fooplate up or down, make
sure to not get into the danger zone with your arms or
legs.
NOTICE
Risk of armrest breakage due to overloading. Please
notice that the armrests are not capable of bearing full
body weight and that they therefore must not be used for
getting into or out of the wheelchair.
The modular design of the power wheelchair and the ease
with which you can swing away the armrests and pull off the
supports make it easy to get into and out of the wheelchair
from/to the side or from/to the front.
Xeno