Changing The Fuse; Wheel Replacement - Ottobock Xeno Gebrauchsanweisung

Maintenance, cleaning and disinfection
INFORMATION
When the joystick is activated while the brakes are un-
locked, the control system emits an error signal on the
control panel. If this is not the case, there is a malfunction
that must be corrected immediately by a specialist dealer.
9.2

Changing the fuse

The fuse (for values see section "Technical data" > Table
"Electrical installation") is located in a fuse holder at the rear
end of the battery case (see fig. 41).
1. Open the cap of the fuse holder.
2. Pull out the fuse.
3. Insert the new fuse into the holder. Make sure that the
fuse is pressed into the centre of the spring contacts and
that it is not at an angle.
4. Close the cap until you feel it snap back into place.
200 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
1
Fig. 41 Fuse holder
1 Fuse housing with open cover and inserted fuse
2 Fuse, removed
9.3

Wheel replacement

NOTICE
Risk of damage due to uncontrolled movements. When
lifting, secure the wheelchair to prevent it from slipping or
tilting to the side by placing a suitable base under the
drive unit support.
2
Xeno