Mounting.instructions.for.the.adaptation.of.the."E-Support".To.the.avantgarde.sl,.V,.Tr,.Or.d; Description; Assembling The Adapter Plate To Avantgarde Sl, V, Tr And D; Side Panel With Height Adjustable Armrest - Ottobock e-support Bedienungsanleitung

Mounting Instructions for the Adaption of the "e-support" to the Avantgarde SL, V, TR, D, CV, CS, or Start Plus
Mounting.Instructions.for.the.Adaption.of.the."e-support".to.the.Avant-
garde.sL,.V,.tR,.D,.cV,.cs,.or.start.Plus
492E24=00000 e-support (low amplification)
492E24=10000 e-support (high amplification)

1..Description

The adaption has been developed in order to mount the "e-support" power assist system to the Avantgarde wheelchair
for active use, models SL, V, TR, D, CV, CS, or the Start Plus.
In dependency of the side panels used with the wheelchair, there are two versions for mounting the adapter to the
wheelchair.
2..Assembling.the.Adapter.Plate.to.Avantgarde.sL,.V,.tR.and.D

2.1 Side Panel with Height Adjustable Armrest

15 mm
66 | Ottobock
To obtain a sufficient distance between side panel and rear wheel, mount the
adapter plate to the outside of the wheelchair.
1
It is necessary to check and possibly readjust the position of the fitting in the
adapter plate. The height of the fitting in relation to the adapter plate is 15 mm.
The Nordlock washers are mounted to the inside.
2
With this version, on each rear wheel of the "e-support" two spacers are scre-
wed one after the other into the threaded bore shown in figure 3.
Thread for
spacer
3
e-support