Changing The Position Of The Support On The Backrest; Changing The Height Setting Of The Support - Ottobock Xeno Gebrauchsanweisung

Operation

Changing the position of the support on the backrest

There are receivers for a support on the right and left side of
the backrest. Several slot holes are provided in the backrest
frame for this purpose. To change the position of the sup-
ports on the backrest proceed as follows:
1. Loosen the two screws.
2. Move the support receiver on the backrest frame along
the slot hole up or down or select another slot hole for
attachment. It is also possible to mount the support re-
ceiver at the same height as the chest belt holder.
3. Fimly retighten the two screws.
Fig. 12 Changing the position of the support on the backrest
148 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
Changing the height setting
The height of the supports is dependent on how far they can
be inserted in to the receiver:
1. Pull the support out of the receiver.
2. Loosen the two screws and move the connection piece
up or down.
3. Fimly retighten the two screws.
The support must be fully guided in the receiver.
Fig. 13

Changing the height setting of the support

Xeno