Seat And Back Width; Armrests - Ottobock Xeno Gebrauchsanweisung

Operation

6.1.2 Seat and back width

The supports are used to set the seat and back width (see
section 6.1.4). There is a setting range of ±40 mm on each
side.

6.1.3 Armrests

CAUTION
Risk of pinching or crushing in the pivot range of the
armrests. When swinging the armrests up or down, make
sure to not get into the danger zone with your fingers, for
example.
The armrests can be swung to the rear to make it easier to
get into and out of the wheelchair.
Fig. 8 Swinging away the armrest
146 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
The position of the armrests can be adapted to the user re-
quirements.
Changing the height setting
To adapt the armrests to the upper arm length of the user,
the corresponding fixing hole on the rear of the backrest has
to be selected:
1. Loosen the two screws that attach the armrest to the
backrest.
2. Remove the armrest.
3. Match the armrest's mounting position with another fix-
ing hole and retigten the screws.
Fig. 9 Changing the armrest height setting
Xeno