Tilting The Rehab Buggy; Using The Cover For The Back Folding Scissor Mechanism; Positioning Belts; Safety Instructions For Qualified Personnel - Ottobock Lisa Gebrauchsanweisung

1) Engage the wheel lock: Press the release lever down with your foot (see fig. 18).
2) Release the wheel lock: Pull the release lever up with the tip of your foot (see fig. 19).
18

6.2.5 Tilting the rehab buggy

1) Screw the tip-assist to the rear frame on the left or right side.
2) To tilt the rehab buggy, place one foot on the tip-assist and pull the buggy towards you (see fig. 20).

6.2.6 Using the cover for the back folding scissor mechanism

The folding scissor mechanism of the back support is covered with a pocket-type cover (see fig. 21). The pocket
can only carry soft or small objects as these come into close proximity with the frame tubes when the back support
is at maximum inclination.
20

6.3 Positioning belts

6.3.1 Safety instructions for qualified personnel

CAUTION
Incorrect approach to the adjustment process
Injuries, malpositions, illness of the user due to adjustment errors
► The belt system may only be installed by qualified personnel.
► The qualified personnel is responsible for individual positioning and fitting of the belt system.
► Excessively tight adjustment of the belt system may lead to unnecessary pain or illness of the user.
► Adjusting the belt system too loosely can cause the user to slide into a dangerous position. In addition, the
fastening snaps could open unintentionally if they slide against hard parts of clothing (e.g. buttons).
► For proper installation and adjustment, follow the instructions for use included with the product.
Lisa
19
21
Use
51