Control Panel, Underside Of Control Panel - Ottobock Xeno Gebrauchsanweisung

Operation
power wheelchair is turned on and off using the keypad;
driving commands can be entered and the status of certain
functions and components can be displayed.
5
4
3
2
1
Fig. 21

Control panel, underside of control panel

1 Joystick
2 Direction indicator, left
3 Warning flasher
4 LCD display
5 On/Off button
6 Mode button
On/Off button
The on/off button is used for switching the power wheel-
chair on and off and for activating the drive-away lock.
156 | Ottobock
Downloaded from www.Manualslib.com
6
7
8
11
9
7 Horn
8 Direction indicator, right
9 Light
10 Programming receptacle
11 Inputs for external
push-buttons
manuals search engine
Mode button
Briefly pressing the mode button increases the speed level.
After reaching the maximum speed level, you can change
back to speed level 1 by pressing the key again (1-2-3-4-5-
1-...). Pressing and holding the button (at least 2 seconds)
activates the "Additional electrical functions" menu (see
section 6.3.6).
10
Horn
The horn will sound as long as the horn button is being
11
pressed.
Warning flasher
Pressing the warning flasher button activates / deactivates
all four direction indicators.
Light
The front and rear lights are activated and deactivated by
pressing the light button.
Direction indicators
The right or left front and rear direction indicators are acti-
vated and deactivated by pressing the "direction indicator,
right" or "direction indicator, left" button respectively. The
direction indicators automatically go out after 20 seconds.
Xeno