Push-Button Module - Ottobock Xeno Gebrauchsanweisung

Setting the time
If the digital clock is activated on the display, you may set the
time. Press the yellow button for at least two seconds. The
display will show 12: and 24: in turn. Pressing the key again
when the display shows 24: will programme the clock to show
a 24-hour display. Pressing the key when the display shows
12: will result in a 12-hour display.
Next, the hours and minutes can be set. The time digits auto-
matically advance one after the other. Press the yellow button
when the desired digits are showed on the display.
Setting the total mileage
When the total mileage counter is shown on the display, you
can switch between km/h and m/h and enter the wheel cir-
cumference. To do so, press the yellow button for at least 2
seconds and then again press the button to select between
the alternating displays (km/h and m/h). The wheel circumfer-
ence can be calculated on the basis of the wheel size and
can be set in the same way the clock is.
Xeno
Downloaded from www.Manualslib.com manuals search engine
Example for a wheel size of 14 inches:
Conversion from inches
to mm 14" x 25.4 = 355.6 mm
C = d x π 355.6 mm x 3.1416 = 1 117 mm
(wheel circumference to be set)

7.4.3 Push-button module

CAUTION
Risk of accidents due to uncontrolled driving charac-
teristics. The push-button module is an option within the
scope of the application of the enAble50 system. Improper
adaption of the push-button control unit to a power wheel-
chair with components outside of the Ottobock modular
system or later modification by the user are impermissible.
The push-button module lets the user directly select addi-
tional electrical functions during normal driving operation.
Accessories
Ottobock 185
|