Steering Lock - Ottobock Xeno Gebrauchsanweisung

Operation
Deactivation via control panel
1. Press the On/Off button to turn on the control.
2. Move the joystick into the front end position until you hear
a beep.
3. Move the joystick into the rear end position until you hear
a beep.
4. Release the joystick.
5. Another beep confirms the successful deactivation of the
drive-away lock.
6. The speed level and battery indicator appear on the LCD
display, and the control unit is ready for driving.
Now the drive-away lock is deactivated and the wheelchair
can be driven.
INFORMATION
If the joystick sequence is not completed correctly, the
drive-away lock remains engaged. Turn the control of the
power wheelchair off and on again and make another at-
tempt at deactivating the drive-away lock.
Deactivation via separate LCD monitor
After switching the power wheelchair on, an information win-
dow appears on the LCD monitor. Deactivation is similar to
"Deactivation via control panel".
164 | Ottobock
Downloaded from www.Manualslib.com manuals search engine

6.3.8 Steering lock

INFORMATION
The steering lock can only be activated in the manner de-
scribed below if the "Steering Lock" parameter is set to
"On". The steering lock parameter is set to "Off" by de-
fault. The factory setting may also have been set to "On"
by the specialist dealer or at the factory according to the
order. Please ask your specialist dealer about the setting
selected for your wheelchair.
The enAble50 control unit in the power wheelchair may be
programmed with the optional "Steering Lock" parameter.
If the steering lock is activated, the caster wheels or the
drive wheels (depending on the type) are set straight ahead.
This makes it easier to negotiate narrow ramps and to use
elevators.
„ When the joystick is deflected forward, the power wheel-
chair always drives straight ahead.
„ When the joystick is deflected backward, the power
wheelchair always drives straight back.
„ Turning is not possible when the steering lock is activated.
„ The warning flasher lights flash when the steering lock is
activated (standard programming).
Xeno