Control Panel; Attaching The Knee Pad - Ottobock Xeno Gebrauchsanweisung

1
Fig. 19

Attaching the knee pad

1 Belt knob
The position of the belt knobs for the knee pad cannot be
changed.
Adjusting the belt length
The width of the knee belt is changed by adjusting the length
of the two belt parts on the right and left of the pad.
Xeno
Downloaded from www.Manualslib.com manuals search engine

6.1.9 Control panel

CAUTION
Risk of accidents and injury due to uncontrolled moving
of the wheelchair. Turn off the control unit of the power
wheelchair before mounting or removing the control panel
or changing its position.
NOTICE
Cable damage. Positioning the cable incorrectly can lead
to pinching and thus damage to the cable. The cable must
not be attached too tightly or too loosely. Avoid bending or
squeezing the cable.
The control panel is attached to a rail which is located be-
neath the armrest. For horizontal adaptation of the control
panel to the arm length of the user, you must loosen the 2
screws on the underside of the armrest using a 3 mm Allen
wrench. You can now slide the control panel backwards
and forwards. If desired by the user, the control panel can
also be mounted on the other side of the power wheelchair.
Operation
Ottobock 153
|