Ottobock Xeno Gebrauchsanweisung Seite 130

Safety instructions
INFORMATION
If the driving mode is changed while driving, the power
wheelchair will accelerate or decelerate.
INFORMATION
The controls of the power wheelchair are protected ac-
cording to protective system IP 54 (push-button module:
protective system IP 64). Both of them can thus be used in
bad weather (e. g. rain). The controls/push-button module
are approved for indoor and outdoor operation and meet
the requirements regarding climate and splashed water.
INFORMATION
After each emergency stop, the controls of the power
wheelchair must be turned on again. In the event of com-
munication problems in the bus system of the controls, the
system triggers an emergency stop and thus prevents any
uncontrolled functions. If the driving function is still not
available after switching the controls on again, unlock the
brakes to activate the push mode. In this case, contact a
specialist dealer as soon as possible.
130 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
INFORMATION
If the controls do not emit an error signal as soon as the
brake lever is activated, this indicates a malfunction. The
settings must be checked by a specialist dealer.
INFORMATION
Manoeuvring is only allowed at reduced speeds.
INFORMATION
When using the power wheelchair, factors such as friction
may lead to electrostatic discharge (high voltage with low
current; electrostatic discharge via the user); however,
this does not represent a health hazard.
Since this may impair comfort – taking into account the
environmental conditions of the user – it can be prevented
by measures realised in custom fabrication (mounting a
mechanical discharge contact / ground strap to the
wheelchair frame).
Electrostatic discharge can also be caused by puncture-
proof tyres. In this case, changing to pneumatic tyres will
prevent this discomfort.
Xeno