Seat Cushion; Lap Belt; Adapting The Seat Cushion Length - Ottobock Xeno Gebrauchsanweisung

6.1.5 Seat cushion

The length of the seat cushion has to be adapted to the seat
depth:
1. Completely open the zipper of the seat cushion cover.
2. Pull half of the insert out of the cover.
3. Measure the length of the insert that has to be cut and
mark this line parallel to the rear e. g..
4. Use a knife to cut off the measured piece.
5. Push the insert back into the cover and close the zipper.
Fig. 14

Adapting the seat cushion length

Xeno
Downloaded from www.Manualslib.com manuals search engine

6.1.6 Lap belt

WARNING
Risk of accident and injury due to improper use of the
standing function. The standing function may only be
used with the chest belt, lap belt and knee pad applied.
The power wheelchair is equipped with a lap belt. This lap
belt serves exclusively to stabilise the user during opera-
tion.
WARNING
Risk of injury due to improper use of the lap belt. The
lap belt must not be used as part of a restraint system
under any circumstances while driving in a vehicle for the
disabled. It must be attached behind the back rest before
each trip.
CAUTION
Risk of injury due to insufficient stabilisation of the
seated person. Always wear the safety belt / lap belt
when driving in public.
Operation
Ottobock 149
|