Adjusting The Angle Of The Elevating Footrest - Ottobock M1 Intro Gebrauchsanweisung

Footrest for short lower leg lengths
The footplate can be moved to the desired position after the clamping screws are loosened
(fig. 60, pos. 1). Make sure to retighten the clamping screws with a torque of 9 Nm after ad-
justments are completed.
6.9 Adjusting the angle of the elevating footrest (Fig� 61)
INFORMATION
Please note that the angle of the elevating footrest/calf support cannot be adjusted (disengaged) un-
der load, otherwise the mechanism may tilt or block.
To adjust the footrest angle, turn the release lever until it hits the stop.
While propping up the footrest bar, set the desired angle. Then carefully let the release lever
turn back. At the next free position, the footrest will snap into place.
M1 Intro · M2 Effect · M3 Hemi · M4 XXL · M5 Comfort · M6 Junior · Asia
58
60
Adjustment / assembly instructions
Ottobock | 77
59