Angle Adjustment Of The Footplate; Adjusting The Lower Leg Length; Adjusting The Angle Of The Elevating Footrest - Ottobock Motus CV Gebrauchsanweisung

6.7 Angle adjustment of the footplate

Prior to adjusting the footplate angle, loosen the screw connections as indicated in the figure .
Subsequently tilt the footplate until the desired angle is achieved.
INFORMATION

6.8 Adjusting the lower leg length

By loosening the set screw, the footplate can be adapted to your lower leg length and to the
thickness of your seat cushion .
Make sure when adjusting the footrest height, that the footrest bar is slid into the swivel segment
at least 40 mm. A marking on the footrest bar indicates how far the bar should be slid in.
INFORMATION

6.9 Adjusting the angle of the elevating footrest

To adjust the footrest angle, turn the release lever up to the stop. While propping up the footrest
bar, set the desired angle. Then carefully let the release lever turn back. At the next free position,
the footrest will snap into place.
Motus CV/CS
Downloaded from www.Manualslib.com
Make sure to re-tighten the loosened screw connections. The proper torque is 6 Nm.
After having made adjustments, retighten the set screw to a torque of 6 Nm.
manuals search engine
A
46
48
Adjustment/Assembly instructions
47
49
Ottobock | 65