Milnor StaphGuard Betriebshandbuch Seite 107

Chapter 1. Controls
1.1. Controls on Mark VI Non-Tilting Washer-extractors
(Document BICWCO02)
1.1.1. Where are the Controls?
1.1.2. Where do I Connect the Data Storage Device?
1.1.3. What are the Operating Controls?
1.1.4. What does this Switch do?
Chapter 2. Normal Operation
2.1. Operating Instructions for Plant Personnel
BICWCO03)
2.1.1. Start Here for Safety
2.1.2. Check Switch Settings
2.1.3. How do I Load a StaphGuard
2.1.4. How do I Select a Formula?
2.1.4.1. Selecting a Local Formula
Table of Contents
Sections
(Document
®
Machine?
103
Table of Contents
Figures, Tables, and Supplements
Figure 1: Ubicación de los controles
[Locations of Controls]
Figure 2: Conexión en serie para la
transferencia de información [Serial
Connection for Data Transfer]
Figure 3: Controles en el lado de carga
(Staph Guard, Mark VI) [Mark VI
Staph Guard Soil Side Controls]
Figure 4: Tablero [Keypad]
Figure 5: Controles regulares en el lado de
descarga en la máquina Staph Guard
[Typical Staph Guard Clean Side
Controls]
Figure 6: Interruptor para seleccionar
Mildata/Local [Mildata/Local Selector
switch]
Figure 7: Botón para inyectar
manualmente los productos químicos
[Manual Supply Flush button]
Figure 8: Interruptor de selección Autospot
[Autospot selector switch]
Figure 9: Seleccionando una fórmula local
o una remota [Selecting a Local or
Remote Formula]
Figure 10: Pantalla para seleccionar una
fórmula local [Select Local Formula
Screen]
Supplement 1: About Load Weight and
Metered Water
Figure 11: Registrando el peso de la carga
en máquinas con contador de agua
[Entering Load Weight for Metered
Water]
PELLERIN MILNOR CORPORATION