Instructions For Use; Power Supply To The Unit; Disconnection From The Mains Power Supply; Startup - RHOSS TCCE 135 Gebrauchsanweisung

I.3

INSTRUCTIONS FOR USE

I.3.1

POWER SUPPLY TO THE UNIT

Fig. 6
1. Emergency push button;
2. Isolator switch
3. User interface panel
4. Electrical board protection door.
To supply power to the unit:
•
Check that the emergency push button has not been pressed
(ref. 1, Fig. 6);
•
Open the protection door of the electrical board (ref. 4, Fig. 6)
using the special key;
• Switch on the isolator switch by turning the red handle clockwise
through 90°.
The Power Supply LED lights up.
I.3.2 DISCONNECTION FROM THE MAINS
POWER SUPPLY
Switch off the isolator switch by turning the red handle anticlockwise
through 90°.
The "power supply" LED switches off
indicating that the unit is no longer
connected to the power supply.
I.3.3

STARTUP

I.3.4

STAND-BY

I.3.5

SHUTDOWN OF THE UNIT

31
SECTION I: USER
Press the ON/OFF, RESET-
DOWN key for 2 seconds.
The LED corresponding to the
function mode which was
active when the appliance was
last switched off lights up, and
the display shows the inlet
water temperature.
The compressor time delay
LED begins to flash.
After the time delay has
elapsed the LED remains lit,
indicating that the compressor
has started to run.
Press MODE once or twice
according to whether the
function mode is winter or
summer.
The LEDs indicating the
summer and winter modes
switch off.
The water inlet temperature
continues to be displayed.
Press the ON/OFF, RESET-
DOWN key for 2 seconds.
The compressor and active
function mode LEDs go out.
The power supply LED
remains lit, indicating that the
unit is connected to the power
supply.