Changing The Fuse; Wheel Replacement; Figure 51 Fuse Holder - Ottobock C1000 DS Gebrauchsanweisung

INFORMATION
When the joystick is activated while the brake is deacti-
vated, the control unit emits an error signal on the control
panel. If this is not the case, there is a malfunction that
must be corrected immediately by a specialist dealer.
9.2

Changing the fuse

The 120 A fuse is located in a fuse holder at the rear end of
the battery case (see Figure 51).
1. Open the cap of the fuse holder.
2. Pull out the fuse.
3. Insert a new fuse into the holder. Make sure that the
fuse is pressed into the centre of the spring contacts
and that it is not positioned at an angle.
4. Close the cap until you feel it snap back into place.
C1000 DS
Maintenance, cleaning and disinfection
Figure 51 Fuse holder
1 Cover open
2 Fuse, inserted
9.3

Wheel replacement

NOTICE
Risk of damage due to uncontrolled movements. When
raising the power wheelchair, e.g. with a jack, secure it
against slipping and tipping sideways by using a suitable
block under the drive unit sustainer.
1
2
Ottobock 211
|