Ordinary Maintenance; Routine Cleaning; Periods Of Inactivity - Moretti Forni T Serie Bedienungsanweisung

4

ORDINARY MAINTENANCE

4.1 PRELIMINARY SAFETY OPERATIONS
WARNING!
Before performing any maintenance operation stop
the appliance as described in the procedure in point 3.3 and cut the power
supply, then disconnect the power supply by disconnecting the power
cable outside the oven.
Operations must only be carried out after the oven has been allowed to
cool down.
All maintenance operations must be carried out by qualified technicians
using suitable accident prevention equipment.
All precautions are of importance to ensure that the oven remains in a
good state, and failure to observe them may result in serious damage
which will not be covered by the warranty, as well as causing risks.
4.2

ROUTINE CLEANING

After carrying out the operations described in point 4.1 above, clean the
appliance as follows:
Every day, at the end of operations and after leaving the appliance to cool
down, carefully remove from all parts of the oven, any residues that might
have collected during baking, using a damp sponge or cloth and a little soapy
water, if necessary. Rinse and dry the areas, being sure to wipe parts with satin
finish in the direction of the finish.
Carefully clean all accessible parts.
NOTE:
Regularly clean the rear vents (fig. 40 part E) for air
intake. A lack of cleanliness can cause parts to overheat.
NOTE:
Clean the belt with a stiff nylon brush.
Slide out the flour trays on the left and right (fig.9 part T); clean and refit
them.
WARNING!
Every day, carefully clean off any fat or grease that
may have dripped during baking as this is a potential fire hazard.
WARNING!
Never clean the appliance with water jets or steam
cleaners. Do not allow water or any cleansers used to come into contact
with electrical parts.
The use of toxic or harmful detergents is prohibited.
NOTE:
Do not clean the tempered glass in doors while it is still hot.
Do not use solvents, detergents containing aggressive substances
(chlorides, acids, corrosives, abrasives, etc. ...) or equipment that could
damage surfaces. Before starting up the appliance again, make sure that
none of the cleaning equipment has been left inside.
4.3

PERIODS OF INACTIVITY

If the appliance is to be unused for a long period:
- Disconnect it from the power supply.
- Cover it to protect it from dust.
- Air the room from time to time.
- Clean it before reusing.
UK/10