Sartorius LMA316PA Betriebsanleitung Seite 83

WLM6009-a10081
Statistics
Instead of an analog display, each display panel can be used to display a statistical value. You
can display the moisture or density in this way.
The statistical value is displayed for all stored measured values. However, you can select indi-
vidual positions in the table and generate a statistical value for these measured values only. See
Statistics (Details on page 77).
The following are displayed:
Whether the statistical value applies to moisture or density and how many positions were used to
generate the statistical value
The arithmetic mean (average)
The standard deviation (RMS)
Settings
You call up this dialog from the menu or by pressing one of the display panels.
Value
1. Press the list field and specify whether the statistics are to be displayed for moisture or density.
2. Press Analogue to display values in the display panel.
See Analogue display.
3. Press Apply. The values are displayed in accordance with the selected settings.
Options
If you select a product for which a large number of measured values have already been stored in
the device, it might take a few minutes for these values to be retrieved.
1. Select the number of values to be retrieved when the device is initialized.
auto
All values stored in the device are retrieved. The number of values which can be stored for a
product is defined in the product properties (
When a process measurement is started, the remaining values are retrieved in the background
so that the interface and gauge are synchronized again.
LMA316PA / LMA321PA - Operator Interface - Reference
page 103).
83