Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WLM6009-a10081
MW device
The settings in this area show the system configuration of your measuring device. The system
configuration may only be edited by Sartorius and can only be viewed by users with access rights
of level 5 or higher.
Printer configuration
O
Note: You need to be logged on with at least level 4 access rights to change these settings.
Before you can use the Print command on the measuring device, you must connect a printer and
set it up using the printer configuration. This can be a printer available on the network or, in the
case of laboratory devices, a directly connected USB printer. In the case of measuring devices
that are controlled via an external PC, no printer entry needs to be created. You can use all avail-
able printers on the external PC as is normal when using Windows.
O
Note: The Printer Configuration plug-in is only available in English.
Add New Printer
You use this function to trigger the creation of a new printer entry. The system prompts you to
enter a name for the new printer. This name is used to display the printer once it has been created
in TMV.
Once you press Apply, you automatically go to the Printer/Device tab, where you can select the
printer you want to use.
The list in the Device field shows all printers that are either connected directly to the measuring
device using a USB cable and are switched on or that are available on the IP network.
You can use the Init function to search for connected printers again if, for example, a printer is
only switched on after the dialog has been called up.
Once you press on Next, you go to the Make/Model/Driver tab, where you can check and
change the printer manufacturer and model. You then press on Add Printer to add the new
printer to the list of TMV printers.
Set As Default
The printer selected in the list is defined as the default printer. If no default printer is defined, the
first printer in the list is used as the default printer.
Printer Options
This tab is for making printer-specific default settings such as the paper size or print resolution.
The displayed options depend on the printer model. If there are several options, you can use the
Up and Down buttons to switch between the different displays.
Press Set Printer Options to save the changed default settings for the printer.
Settings that were changed but not yet implemented are displayed in red.
User configuration
O
Note: You need to be logged on with at least level 5 access rights to change these settings.
A table of users is displayed.
You can sort the table.
LMA316PA / LMA321PA - Operator Interface - Reference
115
Werbung
Inhaltsverzeichnis
