Sartorius LMA316PA Betriebsanleitung Seite 110

WLM6009-a10081
All installed circuit boards are displayed. Up to 4 circuit boards can be configured. With regard to
the configuration, note that only wired outputs (= ports) can be used.
The analog outputs then each deliver 0 mA (or 4 mA) and 20 mA for the set percentage values
and values in mA when the device is started up and for interruptions in measuring. The start value
must not be 0, since this would cause a warning signal to be generated when the device is started
up.
The circuit boards and ports that you use and the signals that can be evaluated depend on the
configuration of your system.
Configuration
This menu has the following sub-items:
– Sensor modes (Details on page 110)
– Communication (Details on page 112)
– MW device (Details on page 115)
– Printer configuration (Details on page 115)
– User configuration (Details on page 115)
Sensor modes
The table lists all available sensor modes.
You need to be logged on with at least level 4 access rights to change these settings.
Sensor modes defined by the manufacturer are indicated by a green tick. User-defined modes
are not marked.
This menu has the following sub-items:
– Edit (Details on page 110)
– Settings (Details on page 112)
– Print (Details on page 112)
– Export (Details on page 112)
– Read (Details on page 112)
Edit
Values
O Note: You need to be logged on with at least level 4 access rights to change these settings.
1. Press a row to select it.
O Note: You can select and edit several rows at a time. You cannot change automatically loaded
sensor modes.
2. Press the control to start editing.
The Sensor mode dialog is displayed.
3. Press an input field.
The Numerical input (Details on page 125) or Text input (Details on page 124) dialog appears.
4. Press Library. Select a sensor mode from the list. The properties of the selected sensor mode
are copied to the dialog box and can now be edited.
110
LMA316PA / LMA321PA - Operator Interface - Reference