Error Messages - Sartorius LMA316PA Betriebsanleitung

WLM6009-a10081

Error messages

Error messages are output in the status line or the display. An error code is indicated by a
preceding E in the display panel and by the abbreviation of the error block (MV/MWT, RE, or MT)
in the status line.
The six-digit error messages are made up of three blocks of 1 or 2 digits each.
Block 1 provides general information on the type of the error.
Error code 2 indicates an MT error - the exact type of the error is specified in block 3. Error code
4 indicates an RE error - the exact type of the error is specified in block 2.
Block 2 indicates that measurements are possible but outside the approved range.
If block 3 displays an error code, no measurements are possible for technical reasons, e.g. be-
cause the sensor is not connected up using a cable. Check the cable connections and contact
the service team if necessary.
Block 1 (MV or MWT = measured value)
General information on error type
128
LMA316PA / LMA321PA - Operator Interface - Reference
Block 2 (RE = range error)
Measurement outside permitted range
Block 3 (MT = measurement task)
Measurement not possible