Sartorius LMA316PA Betriebsanleitung Seite 40

WLM6009-a10081
Adapting the calibration curve
O Note: The 1st display and 2nd display panels show parameters and settings during the
calibration process.
1. Press 1st display to open the Calibration type dialog (simple).
You can open another dialog with expert settings from this dialog or using the menu.
Calibration type
You can modify the calibration curve.
If there is no directly proportional relationship between the reference moisture and the measured
moisture, select a non-linear calibration type here. Since products can display different behaviour
in different measurement ranges, you can split the calibration curve into various segments. In the
simple calibration mode, the splitting of segments is determined automatically.
Here, you determine whether the calibration curve has an extremum and specify the way in which
temperature and density/moisture are to be taken into account.
Complex curves require a high number of measured values.
If measured values, reference values, or correction values do not fall into the range defined in the
global settings (
measurement ranges or take further calibration measurements.
Expert mode
You can open the expert mode from the Calibration type dialog.
You can manually adjust previously defined settings here. You can move the automatically calcu-
lated limits of the individual curve segments.
If you select Manual correction for the correction of the temperature or density/moisture, a slide
control is displayed in the graphical depiction of the calibration curve. You can use it to manually
correct the calibration curve.
40
1st display:
Calibration type
page 93), the system issues an error message. Change the settings for the
Manual correction using
slide control or by entering
numbers in the graphical
depiction
LMA316PA / LMA321PA - Calibration
2nd display:
Values