Sartorius LMA316PA Betriebsanleitung Seite 60

WLM6009-a10081
Backup on USB stick
1. Insert the provided USB stick into the USB port on the front of the device.
O Note: You may have to wait a few seconds until the USB stick is detected and thus ready for use.
2. Choose Service > Backup. The Backup dialog appears. By default, the Backup function is
selected in the upper panel.
3. Press Apply. The backup is saved to the USB stick; the Backup dialog then closes automatically.
A name is automatically generated for the backup file from the current date and time. This
prevents the accidental overwriting of an old backup file when a new backup is saved.
Backup on external PC
1. Choose Service > Backup. The Backup dialog appears. By default, the Backup function is se-
lected in the upper panel.
2. Press Browse. A typical Windows dialog appears, prompting you to navigate to the required stor-
age location for the backup file.
A name is automatically generated for the backup file from the current date and time. This
prevents the accidental overwriting of an old backup file when a new backup is saved. You can
change the file name if required.
Attention:If you change the name of the backup file, you must observe the convention
Backup_*.lua. If you fail to do so, you will not be able to restore the backup later on.
3. Press Save. The backup is saved to the PC and the Backup dialog closes automatically.
Restore
You can use this function to restore a previously created backup state.
Caution:When you carry out a system restore, all measurements, inputs, and so on made since
the backup was saved are lost. You may wish to back up the current state of the system before
running the Restore function.
Prerequisites: The measuring device is switched on and you are logged in with level 4 access
rights or higher (see Creating a backup).
1. Stop any measurements that are currently in progress.
2. Insert the USB stick containing the backup files into the USB port on the front of the device (omit
this step if restoring a backup saved on an external PC).
O Note: You may have to wait a few seconds until the USB stick is detected and thus ready for use.
3. Choose Service > Backup. The Backup dialog appears.
4. Choose Restore from the top panel. The bottom panel now displays a list of all available backup
versions.
5. Select the required backup from the list and press Apply. The data is loaded and the state stored
in the selected backup file is restored.
If you want to restore a backup saved on an external PC and the backup in question does not
appear in the list, press Browse. A typical Windows dialog appears, prompting you to navigate
to the storage location of the required backup. Select the required backup file and press Open.
60
LMA316PA / LMA321PA - Service and maintenance