Sartorius LMA316PA Betriebsanleitung Seite 50

WLM6009-a10081
Adding a new user
Prerequisite:
You own level 5 access rights (Service).
1. Open the menu and choose System settings > Configuration > User Config. (
2. Select New from the User configuration.
3. Input the following details to the User new dialog:
User name: Name that the new user must enter to log on
Last name / First name: Details needed to more easily identify a user in the user administra-
tion database
Password input: Password to be entered when logging on (for security reasons, placehold-
ers can be seen only when you enter the password)
Password repeat: Enter the password again to exclude typing errors in the first entry.
User level: Pick a level from the dropdown list.
Default user: If no user has been previously defined as the default user, tick the box next to
this entry to set the user you are creating as the default user.
O Note: Important information about the default user:
The default user does not need to log on when they start the unit. We therefore strictly
recommend to only define a low level user (level 0 or 1) as the default user.
You can only have one default user at a time.
A default user is not really a must: If no default user is defined, every user - regardless of their
access level - must log on after starting the unit.
4. Click on Apply when all parameters are set. The new user will be added to the list.
5. Select the User configuration and click on Apply as well.
Notes on editing the user profile
To change the settings of a user record (e.g. to assign a new password), display the User confi-
guration page, select the appropriate entry, and press Edit. The Edit user dialog will pop up
showing the settings of the selected user. Edit the entries as you would do when creating a new
user record.
To remove a user from the list, select the appropriate entry and press Delete. After confirming
the security prompt, the user record will be deleted.
You can neither delete the default user nor the last level 5 user.
9.2 Sensor modes
A sensor mode is assigned to each product. The modes supported by a sensor are normally
detected automatically by devices that are connected to the evaluation unit by a data cable. When
you create a product, you therefore only need to select a mode from the list.
If multiple sensor modes exist, the optimal sensor mode must always initially be determined using
a compression test (see page 32).
It is best,
if the compression lines, representing different moisture values, intersect in one point, ideally the
zero point and
if a sufficient number of measuring signals (approx. 3-20 MHz of frequency offset) is available.
50
LMA316PA / LMA321PA - Other functions
page 115).