Sartorius LMA316PA Betriebsanleitung Seite 53

WLM6009-a10081
9.3 Setting up printers
Before you can directly print from the measuring instrument, you must connect a printer to the
unit.
If the measuring instrument is connected using an IP network, in principle, you can use any printer
that can be accessed in this network. However, you can also connect a printer directly to the USB
port of the measuring device.
O Note: To configure printers, you must be logged on with level 4 access rights at the very least.
To set up a printer, you choose System settings > Configuration > Printer Config.
( page 115).
Notes about printing directly from the measuring instrument
The measuring instrument works with the printing system CUPS that is used in LINUX.
When you print data, TMV displays a print dialog that is similar to the normal print dialog on your
PC. However, the dialog differs in appearance depending on the selected printer.
Sartorius delivers printer drivers for various standard printers. If no suitable driver is available for
your printer, you must contact Sartorius.
Setting up a network printer
Prerequisites:
– You are logged on and own level 4 or 5 access rights.
– The printer is set up in the network.
– The measuring instrument is connected to the IP network.
1. Select System settings > Configuration > Printer config. The Printer Configuration dialog is
displayed:
O Note: The Printer Configuration plug-in is only available in English.
2. Choose Add New Printer to add a printer.
LMA316PA / LMA321PA - Other functions
53