Sartorius LMA316PA Betriebsanleitung Seite 121

WLM6009-a10081 LMA316PA / LMA321PA - Operator Interface - Reference
Submit to sensor mode
The sensor mode you selected is adapted to the test results.
Regression/Scale/Graph Type
The parameters you set here adjust the depiction of the graph.
Graphic - Print
You can print the graphical depiction of the measured values.
See page 53 for information on how to connect a printer.
The graph is printed as it appears on the screen.
Measurement
O Note: The 2nd display panel shows the measurement settings for the compression test.
Press this field to open the Measurement settings dialog.
Use this dialog to define the measurement procedure.
continuously
Activate this option if you want to continuously record values for the compression test (process
measurement devices). Measurements are then taken every second. Deactivate this option if you
want to start and save each measurement manually (laboratory measurement devices).
overwriting
Activate this option to overwrite old measured values once the memory capacity reserved for the
test is exceeded.
Memory
Specify the amount of memory to be reserved for the test here.
Current type
Determine the way the measured values are depicted in the graph here.
Information
Program version
The version number of the currently installed software is shown here.
Backup/Restore
Depending on the device and system configuration, backups can be saved to a connected USB
stick or an external PC.
In the Backup dialog, press the upper list box and choose Backup ( page 121), Restore
( page 122), or Restore factory settings ( page 123).
Backup on USB stick (only for laboratory devices)
Prerequisites
Before using this function, insert a USB stick into the USB port at the front of the device.
Sufficient memory must be available on the USB stick.
1. Press Apply.
121