Sartorius LMA316PA Betriebsanleitung Seite 127

WLM6009-a10081
13.12 Messages
Status line messages (Details on page 127)
Error messages (Details on page 128)
Status line messages
Below is a list of the messages that are output by the device into the status line (Status line
(Details on page 67)).
Status line display
Sensor empty
Measurement in progress
Sensor empty?
Sensor half full?
MW value=
Out of range!
LMA316PA / LMA321PA - Operator Interface - Reference
Action
The device is ready for measurement and is waiting to be
filled.
The device is attempting to take a measurement. If no meas-
ured value is displayed, wait for further information.
Carry out empty sensor adjust (
(only for bypass measurement)
The sensor seems empty.
Check the following device settings:
Level sensor setting
Macro programming
Device version
Carry out calibration.
Switch to Measurement mode.
No non-linear calibration can be carried out for the microwave
value as there is no valid value in this range.
page 70)
127