Sartorius LMA316PA Betriebsanleitung Seite 103

WLM6009-a10081
13.6 Product settings
This is where the (data set) for a new product is entered.
This is where the parameters for a product are changed.
This menu has the following sub-items:
– Edit (Details on page 103)
– Settings (Details on page 106)
– Print (Details on page 106)
– Export (Details on page 106)
The currently selected product is indicated by a green tick.
Edit
You can change the parameters for a product.
This menu has the following sub-items:
– Values (Details on page 103)
– Delete (Details on page 104)
– Copy (Details on page 104)
– New (Details on page 104)
Select Edit from the Product settings menu.
The table is now displayed in edit mode, i.e. the controls (
rows are displayed at the bottom.
Protected products are indicated by a lock. You cannot alter the calibration of a protected product.
Values
1. Select Product settings > Edit > Values.
2. Press a row to select it.
O Note: Settings for several products can be selected and edited at the same time. This is helpful,
for instance, if several products refer to a common calibration or if the same sensor mode is used
by several products. If this is the case, (Multi) is displayed in the header line of the Product
settings dialog.
3. Press the control to start editing.
The Product properties dialog appears.
4. Press an input field.
The Numerical input (Details on page 125) or Text input (Details on page 124) dialog appears.
Products are described in the Product settings > New (Details on page 104) section.
O Note: If you assign a new ID number, the selected products are given new and unique ID numbers
on the basis of the entered number. The system automatically increments the number by one in
each case.
5. Press Apply to accept the changed values.
6. Press Close. The editing of the values is complete.
LMA316PA / LMA321PA - Operator Interface - Reference
page 70) for selecting one or more
103