WMF ESPRESSO PRO Bedienungsanleitung Seite 50

The grind setting is too fine, resulting in a too
•
long extraction time (e. g. 40 seconds).
The brewing temperature is too low.
•
The grinding quantity is too low.
•
The crema of my espresso dissolves quickly:
The brewing temperature is too high.
•
The extraction time is too short (e. g. only 10
•
seconds).
7| SETTINGS
The device is factory preset. The settings can be
adjusted individually as needed.
By pressing the settings button, the respective
settings are shown on the display and can be
adjusted by pressing the (+/–) buttons.
Press the setting button again to switch to
the next setting. The adjusted values are saved
when you switch.
NOTE
The setting process can be canceled by press-
•
ing the on/off button. Any changes to the dis-
played setting will not be saved.
The setting process will be automatically can-
•
celed after 30 seconds of inactivity. Any
changes to the displayed setting will not be
saved.
7.1| GENERAL SETTINGS
The following settings are accessed by pressing
the settings button and displayed as icons on
the control panel (F) in the order listed below:
Grinding time:
Water quantity:
Brewing temperature:
Pre-infusion time:
Water hardness:
Water filter:
The individual settings are factory-set as
follows:
Grinding time:
Water quantity:
Brewing
temperature:
Pre-infusion
time:
Water hardness:
Water filter:
Grinding Time
The amount of coffee powder for the 1- or
2-cup filter basket is controlled via the grind-
ing time in seconds. To adjust this value individ-
ually, proceed as follows:
1| Select the grinding time setting.
2| Press the 1 or 2-cup grinding button to
select the corresponding grinding time. The
selected button flashes.
50
1 cup: 8 seconds
2 cup: 12 seconds
1 cup: 25 ml
2 cup: 50 ml
hot water: 80 ml
92 °C / 198 °F
2 seconds
H4
No