Seat Angle - Ottobock Skippi Gebrauchsanweisung

Once the backrest is in the desired position, release the
strap to let the locking mechanism engage in the next avail-
able position.
Fig. 15 Release strap for the backrest

6.1.2 Seat angle

CAUTION
Risk of injury due to improper adjustment work. The
user must not sit in the wheelchair during seat angle ad-
justments.
Skippi
Downloaded from www.Manualslib.com manuals search engine
INFORMATION
Remove the fuses for shipping or when the power wheel-
chair is not being used for an extended period of time.
The seat angle can be changed using the seat tilt function if
the power wheelchair is equipped with an electric seat tilt
(see chapter 7.2.2).
The power wheelchair offers three different seat angle set-
tings (-6°, +3° and +12°).
1. Loosen the two Allen head screws located at the front
below the seat (Fig. 16).
2. The desired seat angle can be set by placing the pin in
the corresponding hole.
3. Tighten the Allen head screws properly again after mak-
ing the adjustment.
4. Check that the retaining clip on the pin is closed every
time after the seat angle is adjusted.
Operation
Ottobock 127
|