Safety; General Safety Advice; General Hazards At The Workplace - ECOLAB ULTRAX Cube Betriebsanleitung

2

Safety

2.1

General safety advice

DANGER!
If you believe that the system can no longer be operated safely, the system
must be taken out of service immediately and secured so that it cannot be
used inadvertently.
This is the case if the system or system components:
– show visible damage,
– no longer appear functional,
– has/have had prolonged periods of storage under unfavourable
conditions (perform functional check).
The following regulations must always be observed when handling
the system:
– Any work on the system or system components as well as the operation
of the system may only be carried out by trained and authorised
specialist personnel.
– Before any work takes place on electrical parts, the system must be
disconnected from the power supply and protected against being
switched back on.
– The safety regulations and the prescribed protective clothing must be
complied with when working with chemicals.
– Attention must be paid to the information included on the product data
sheet of the dosing medium used.
– The system must only be operated with the supply and control voltage
specified in the Technical Data section.
2.2

General hazards at the workplace

Risk of slipping
DANGER!
Slipping hazards are marked by the symbol opposite.
Spilled chemicals create a risk of slipping when wet.
WARNING!
Risk of slipping due to fluid in the operation and provisioning area!
– Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard caused
by leaking fluids.
ENVIRONMENT!
Immediately soak up any leaking liquids with a suitable binding agent and
dispose of properly.
9
Safety
417101113 Rev. 9-08.2019