WARNING!
Risk of slipping due to escaping chemicals
Chemicals leaking in the working and preparation area can cause slipping and
injuries.
– Wear non-slip, chemically resistant shoes when working.
– Always have a suitable binding agent available (according to the chemical
product safety data sheet).
– Seal off the area with the escaping chemical.
– Immediately collect chemicals that have leaked or spilled and dispose of
them properly.
– If necessary, place the chemical container in a trough to collect any
escaping chemicals.
WARNING!
Components and hoses under pressure
Components and hoses under pressure can move in uncontrolled manner and
cause injuries.
To ensure process safety:
– Close the shut-off valves of the pressurised media and, if possible, secure
them with a lock against unauthorised opening.
– Switch the station to a depressurised state.
– Wait until the standstill position is reached.
– Release connections only when depressurised.
– Ensure that no liquids escape unintentionally.
WARNING!
Risk of injury from automatically starting components
With some components, an automatic start-up is already started as soon as
the power supply is connected or restored after a power failure. This is done
without first actuating a switch or button and can lead to injuries.
– Make sure that there are no persons in the danger zone.
– Ensure operational readiness before connecting the power supply.
– Take suitable higher-level measures to prevent an automatic restart after a
power failure.
CAUTION!
Risk of injury from damaged or unsuitable tools
Injuries may result from the use of damaged or unsuitable tools.
– Use only undamaged tools.
– Use only the tool intended for the specific purpose (e.g. suitable drills).
51
Start-up
MAN053089 Rev. 1-11.2023