Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12.2
Dismantling
DANGER!
Danger of injury in case of improper removal!
Dismantling may only be carried out by qualified personnel using PPE.
Stored residual energy, components with sharp edges, points and corners, on
and in the system, or on the required tools can cause injuries.
Thoroughly rinse all components that come into contact with the product to
remove chemical residues.
DANGER!
Danger to life in case of contact with live components
Before commencing dismantling, ensure that the device has been fully isolated
from the power supply. Activated electrical components can make uncontrolled
movements and lead to serious injury.
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools. Use the correct tools.
The procedure for dismantling is as follows:
1.
Make sure you have sufficient space before starting all tasks.
2.
Drain operating fluids and consumables and remove the remaining processing
materials; dispose of them in an environmentally-friendly way.
3.
Clean assemblies and components properly and disassemble them in compliance
with applicable local occupational health and safety and environmental protection
regulations.
4.
Always handle open, sharp-edged components carefully.
5.
Keep the workplace tidy and clean. Loose components and tools lying on top of or
around each other are sources of accidents.
6.
Depressurise the system and pressure line.
7.
Dismantle components properly.
8.
Observe the heavy weight of some components. If required, use lifting gear.
9.
Support the components to avoid them falling or tipping.
NOTICE!
In case of doubt, always consult the
Decommissioning, dismantling, environmental protection
Ä
'Manufacturer' on page 15 .
81
MAN053089 Rev. 1-11.2023
Werbung
