Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Maintenance
– If leaks are detected, immediately press the emergency stop button, locate
the leak and seal off the area.
– Do not operate the station again until after the leaks have been repaired.
Risk of burns due to improper connection of the chemical containers
Improper connection of the containers can cause chemical leaks and severe
burns.
Ensure the following:
– The connection is carried out carefully and according to the regulations.
– Wear the prescribed PPE.
– Check for leaks.
WARNING!
Risk of slipping due to escaping chemicals
Chemicals leaking in the working and preparation area can cause slipping and
injuries.
– Wear non-slip, chemically resistant shoes when working.
– Always have a suitable binding agent available (according to the chemical
product safety data sheet).
– Seal off the area with the escaping chemical.
– Immediately collect chemicals that have leaked or spilled and dispose of
them properly.
– If necessary, place the chemical container in a trough to collect any
escaping chemicals.
WARNING!
Components and hoses under pressure
Components and hoses under pressure can move in uncontrolled manner and
cause injuries.
To ensure process safety:
– Close the shut-off valves of the pressurised media and, if possible, secure
them with a lock against unauthorised opening.
– Switch the station to a depressurised state.
– Wait until the standstill position is reached.
– Release connections only when depressurised.
– Ensure that no liquids escape unintentionally.
WARNING!
Risk of injury from automatically starting components
With some components, an automatic start-up is already started as soon as
the power supply is connected or restored after a power failure. This is done
without first actuating a switch or button and can lead to injuries.
– Make sure that there are no persons in the danger zone.
– Ensure operational readiness before connecting the power supply.
MAN053089 Rev. 1-11.2023
» Continued on the next page
60
Werbung
