Siemens SINUMERIK 840Di sl Inbetriebnahmehandbuch Seite 479

01/2006
[DriveTextFiles]
ALDEV_80E5=f:\dh\mb.dir\aldvs_
ALDRV_80E5=f:\dh\mb.dir\aldrs_
;ALDEV_808F=f:\dh\mb.dir\aldvu_
;ALDRV_808F=f:\dh\mb.dir\aldru_
ALDEV_x=f:\dh\mb.dir\aldvp_
ALDRV_x=f:\dh\mb.dir\aldrp_
[IndexTextFiles]
ALNX=f:\dh\mb.dir\alnx_
ALSI=f:\dh\mb.dir\alsi_
[DEFAULTPRIO]
CANCEL=100
RESET=100
POWERON=100
NCSTART=100
PLC=100
PLCMSG=100
MMC=100
[PROTOCOL]
Filter=Ausdruck
Records=150
DiskCare=−1
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl/840Di sl/840D/810D IBN HMI (IAM) - Ausgabe 01/2006
; drive and device type specific alarm text files
; default definition of the priorities of the different alarm types
; This section defines different characteristics of the protocol that
; specifies how particular error messages are to be registered.
Details zur Bildung von Filterausdrücken zur Steuerung des Meldungsan-
falls finden Sie im Kapitel 2.4.2 Alarm-Protokoll einstellen.
; Criteria for selecting the alarm messages to be recorded. The notation
; is described in SINUMERIK 840D OEM package HMI User's Manual.
; Characterizes the numbers of entries in the log file. If the actual
; number exceeds this value, the server starts to override old entries
; (principle: ring buffer)
; Mode of alarm protocol writing
; if a number of less than -1 is specified, this number of protocol files is
; parallely held, and one of them is actually used
; if a number of -1 is specified, the protocol-file is not automatically updated
; if 0 is specified the protocol file is immediately updated
; if a number above 0 is specified, the protocol file is updated after the
; specified number of seconds elapsed with no intermediate alarm state
; changes. t he protocol-file is always updated when you send the
; DDE-Command: "AlarmProt" to the MBDDE-server
; (principle: ring buffer) ---------------------------------------------------------------
# attention: the mode changed from V4 to V5 !
Inbetriebnahme HMI-Advanced (IM4)
2 Funktionen und Parameter einstellen
IM4/2-97