Residual Risks; Fundamental Hazards - RK Rose+Krieger MultiControl II duo Montageanleitung

Misuse

2.3 Residual risks

2.3.1 Fundamental hazards

Tripping hazard as a result of
cables
20.08.2021
Intended use also includes adherence to all the information pro-
vided in these instructions.
Any application other than or which extends beyond the intended
use is considered misuse.
Control unit RK MultiControl II duo/RK MultiControl II quadro
WARNING!
Danger in the event of misuse!
Misuse of the control unit can lead to hazardous
situations.
– Never use the control unit or its modules in
potentially explosive areas.
– Never use the control unit outdoors.
– Never operate the control unit outside of the
specifications indicated in
nical data" on page 222.
– Never operate the control unit outside of the
ambient conditions indicated in
"Conditions at the installation site" on page 149.
– Never operate the control unit with any drives
other than those listed as compatible drives in
Ä Chapter 3.4 "Drives" on page 141.
– Never operate the control unit in case of any
damage to the mains supply cable, housing,
motor cable, hand switch or other control
cables.
– Never operate the control unit when the housing
is open.
– Never convert or retrofit the control unit or its
modules to change the area of application or the
usability.
CAUTION!
Tripping hazard as a result of exposed cables!
If the cables on the control unit are not routed
properly, there is a risk of injury if persons trip or
fall over them.
– Route cables safely and properly so that tripping
hazards are prevented.
Residual risks > Fundamental hazards
Ä Chapter 10 "Tech-
Ä Chapter 5.2
Safety
129