Functional Description - TR-Electronic AD 582 Serie Gesamt-Bedienungsanleitung

5.1.2 Functional description


The inputs NEW_PRES_MULTI and NEW_PRES_SINGLE are always read and
output to the TR_Pres_Multi and TR_Pres_Single outputs, irrespective of
the signal status of the other inputs. Once the preset block has been started via
the REQ input, the inputs NEW_PRES_MULTI and NEW_PRES_SINGLE may no
longer be changed.

The preset block is executed with the rising edge of the REQ input. The VALID
and
TR_Pres_Request and BUSY are set to 1.

The measuring system then executes the preset adjustment function. The time
for resetting the REQ input to 0 has no influence on the further execution of the
preset adjustment function.

When the preset adjustment function has been executed, the measuring system
sets the iParOK value of the measuring system F-IO data block and thus the
TR_IPAR_OK input to 1. With setting of the TR_IPAR_OK input, the
TR_Pres_Error input checks whether the preset adjustment function was
successfully executed. If the TR_Pres_Error input has the value 1, the ERROR
output is set to 1. Otherwise the VALID output is set to 1. With setting of the
TR_IPAR_OK input, the TR_IPAR_EN and TR_Pres_Request outputs are also
reset to 0.

When the TR_IPAR_EN output has been reset to 0, the measuring system resets
the iParOK value of the measuring system F-IO data block and thus the
TR_IPAR_OK input to 0.

With resetting of the TR_IPAR_OK input, the BUSY output is reset to 0.
Execution of the preset block is complete.
Printed in the Federal Republic of Germany
08/06/2021
ERROR
outputs are
TR-ECE-TI-DGB-0292 v02
reset to 0. The
TR_IPAR_EN,
outputs
 TR-Electronic GmbH 2016, All Rights Reserved
Page 133 of 159