Parameterization; Setting The Iparameters - TR-Electronic AD 582 Serie Gesamt-Bedienungsanleitung

4.3 Parameterization

4.3.1 Setting the iParameters


The iParameters can be set by selecting the Symbol for the measuring system
--> Double click on the slot item CD_75_-EPN E/A --> Select the register
Parameters.
If different parameter values are required, as shown above, a F_iPar_CRC
calculation must occur for this new parameter data set, see chapter "Parameter
Definition / CRC Calculation" on page 48. The calculated value must then be entered
in the parameter data set for the F-Parameters under F_iPar_CRC, see chapter
"Setting the F-Parameters" on page 66.
Printed in the Federal Republic of Germany
07/15/2015 TR - ECE - TI - DGB - 0233 - 03
 TR-Electronic GmbH 2013, All Rights Reserved
Page 65 of 79