B. Braun Aesculap OrthoPilot Elite FS112 Gebrauchsanweisung/Technische Beschreibung Seite 17

Issue
"No camera could be detected"
error message
"No foot switch could be detected"
error message
"Footswitch seams to be defective"
error message
"Battery level is critical" error mes-
sage
Error message appears in the selec-
tion of an application tile.
Error message "Patient data not
filled in" appears when selecting an
application tile.
Identification/cause
®
Connection to OrthoPilot 4 wireless camera dis-
rupted:
■
Device is switched off.
■
Device is not connected.
®
Connection to OrthoPilot 4 wireless camera dis-
rupted:
■
No power supply
■
Internal battery is dead.
®
Connection to OrthoPilot 4 wireless camera dis-
rupted:
■
Power supply defective.
■
Internal battery defective
■
Camera defective
®
Connection to OrthoPilot 4 wireless camera dis-
rupted:
■
Radio network disrupted
®
Connection to OrthoPilot 4 wireless footswitch
disrupted:
■
Device is switched off
■
Device is not connected
®
Connection to OrthoPilot 4 wireless footswitch
disrupted:
■
Battery dead
■
Issue
■
Footswitch control defective
®
Connection to OrthoPilot 4 wireless footswitch
disrupted:
■
Footswitch software crashed
■
Footswitch control defective
®
Connection to OrthoPilot 4 wireless footswitch
disrupted: wireless footswitch battery is nearly
empty.
Application does not start, because the desired
application is not registered.
Application is started before patient data was
®
entered into the OrthoPilot 4 home screen.
Remedy
Select the "More info" button and follow the instructions for
troubleshooting, see Chapter 7.4.
Connect to external power supply.
Have the product repaired by the Aesculap Technical Service.
Contact Aesculap Technical Service.
Select the info button and follow the instructions for trouble-
shooting, see Chapter 7.4.
Finish the navigated operation by data capture via touch-
screen.
Have the product repaired by the Aesculap Technical Service.
Press the right and left pedals of the foot switch at the same
time for at least 5 seconds to perform a reset and connect to
the footswitch again (select the info button and follow the
instructions for troubleshooting).
If the problem persists, have the product repaired by the
Aesculap Technical Service.
Have the product repaired by the Aesculap Technical Service.
Contact Aesculap Technical Service.
Enter the patient data, see Chapter 7.1.
en
15