Ultradent Genius Bedienungsanleitung Seite 8

4- FWD/REV: Toggles motor between forward and reverse rotations. (In reverse rotation, unit is beeping).
AR MODE: Sets the type of autoreverse:
5-
"STP" - Autoreverse disabled:
A.
Motor stops without switching to reverse rotation (Fig. 8).
B. "AR" - Standard autoreverse:
When the file reaches set torque value, the motor switches to reverse rotation until stopped. It will restart in forward rotation.
Note: This function applies only if the torque is not set to maximum value (Fig. 9).
"SAR" - Special autoreverse:
C.
When the file reaches set torque value, the motor switches to reverse rotation until the file is released. The motor then returns
to forward rotation. Note: This function applies only if the torque is not set to maximum value (Fig. 10).
Note: The user is notified with a beep when applied torque reaches 75% of set torque value, and again when applied
torque exceeds that value.
Always verify set values before using the device. Improper use may result in bodily injury.
b. Reciprocating mode
Each program has been configured by the manufacturer with identical information (Fig. 11):
• Reduction ratio: 8:1
• Rotations/minute: 350 rpm
• Angular value in forward rotation: 90°
• Angular value in reverse rotation: 30°
The indicated parameters are only examples. To minimize risk, comply with the speed recommendations issued
by the manufacturer of the rotary instrument and contra-angle being used
com/documents.
First line displays:
• Mode currently in use: "Reciprocating / Rotating"
• Program: From P1 to P10
Second line displays:
• Reduction ratio of the contra-angle (left)
"Ratio" button followed by +/- buttons changes the contra-angle's reduction ratio.
• Angle of clockwise rotation (right)
"FWD" button followed by +/- buttons adjusts the forward rotation angular value.
The third line displays:
• Currently set speed (left).
The "RPM" buttons followed by +/- buttons adjusts the speed.
• The angle of counterclockwise rotation (right)
The "REV" button followed by +/- buttons adjusts the reverse rotation angular value.
• Device programming:
RATIO: Sets the contra-angle's reduction ratio. The following table shows the possible reduction ratios:
1-
1:1
RPM +/-: Sets the motor speed of rotation. See the table below:
2-
1:1
1000
1500
2000
2500
3000
3500
4000
4500
RPM
5000
5500
6000
6500
7000
7500
8000
8500
9000
8
Operating Manual ● Genius
®
6:1 8:1
6:1
150
200
250
300
350
400
450
500
550
600
650
700
750
800
850
900
950
Endodontic Motor ● J28629 ● V4 ● (16) ● 10/2016 ● NO69US010F
16:1
Reduction Rate
8:1 16:1
125 100
150 150
200 200
250 250
300 300
350 350
400 400
450 450
500 500
550 550
600 600
650
700
750
800
850
900
www.ultradent.com or www.satelec.
20:1 32:1
20:1
100
120
150
200
250
280
300
350
400
450
500
32:1
100
150
175
180
200
250
280
300