Yamaha RD400 Betriebsanleitung Seite 117

1. Cotter pin
2. Axle nut
3. Sprocket shaft nut
4. Lock nut
5. Adjusting bolt
6. Marks for alignment
1. Goupille
2. Ferou d'axe
3. Ferou d'axe de pignon
4. Contre ecrou
5. Ecrou de reglage
6.
Reperes de reglages
1. Splint
2. Achsmutter
3. Kettenrad-Schaftmutter
4. Kontermutter
5. Einstellschraube
6. Bezugsmarken für Einstellung
ment (There are marks on each side of
rear arm and on each chain puller; use
them t o check f o r proper alignment).
N O T E :
Before adjusting, rotate rear wheel
through several revolutions and check
tension several times t o f i n d the tightest
p o i n t . A d j u s t chain tension w i t h rear
wheel in this " t i g h t c h a i n " position.
- 1 0 7 -