Yamaha RD400 Betriebsanleitung Seite 109

1. Adjuster 1. Ajusteur 1. Einstellschraube
2. Lock nut 2. Ecrou de blocage 2 Sicherungsschraube
1. Adjuster 1. Ajusteur 1. Einstellschraube
2. Lock nut 2. Ecrou de blocage 2. Sicherungsmutter
1. Loosen the adjuster locknut (for pedal
height).
2. By turning the adjuster bolt clockwise or
counterclockwise, adjust the brake pedal
Position so that its t o p end is approx.
5 m m below the f o o t rest t o p end.
3. Tighten the adjuster l o c k n u t .
4. Loosen the brake rod adjuster locknut
and screw brake rod d o w n w a r d until
there is noticeable freeplay between rod
and master cylinder.
5. T u r n in the- brake rod u n t i l it lightly
touches the master cylinder, then t u r n it
o u t by approx. 1-1/2 turns (for proper
freeplay).
6. Tighten the brake rod adjuster locknut.
( - C A U T I O N :
T h e pin hole mark o n brake rod must n o t
show above l o c k n u t .
— 9 9 -