Setting The Bluetooth Interface Wilo-Smart Connect Module Bt; Application And Function Of Cif Module; Device Settings; Display Brightness - Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung

13.7 Setting the Bluetooth interface
Wilo-Smart Connect module BT
...External interfaces
Analogue input (AI3) function
Not configured, 0 – 10 V
Function analogue input (AI4)
Not configured, 0 – 10 V
Wilo Net settings
ID0, termination: switched off
Bluetooth settings
Wilo-Connect module plugged
Fig. 87: Bluetooth interface setting
Fig. 88: Bluetooth interface
13.8 Application and function of CIF
module
14

Device settings

Device settings

Display brightness

Current: 100 %
Country/language/units
Adaptation of the presentation
Bluetooth On/Off
Current: Switched off
Key lock on
Key lock: Not active
Fig. 89: Device settings
14.1 Display brightness
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
As soon as the Wilo-Smart Connect Module BT is plugged into the Wilo-Connectivity inter-
face, the "Settings – External interfaces – Bluetooth setting" menu appears on the display.
Setting the parameters
of the Wilo Connect Module
"Bluetooth".
The following settings are possible (Fig. 88):
• Bluetooth: The Bluetooth signal of the Wilo-Smart Connect Module BT can be switched
on and off.
• Connectable: It is permitted to establish a Bluetooth connection between the pump and a
mobile end device with Wilo-Smart Connect app (ON).
It is not permitted to establish a Bluetooth connection between the pump and a mobile
end device with Wilo-Smart Connect app (OFF).
• Dynamic PIN: When a connection to the pump is established with a mobile end device us-
ing the Wilo-Smart Connect app, a PIN appears in the display. This PIN must be entered
into the app to establish a connection.
Two PINs are available for selection via "Dynamic PIN":
• OFF: Each time a connection is established, the last four digits of the S/N serial number of
the Wilo-Smart Connect Module BT are shown in the display. The S/N number is printed
on the rating plate of the Wilo-Smart Connect Module BT. This is called a "static PIN".
• ON: A new PIN is always dynamically generated and shown in the display each time a con-
nection is established.
If the menu item "Bluetooth setting" does not appear even though the Wilo-Smart Connect
Module BT is plugged in, check the LED display on the module. Analyse the fault using the
user manual for the Wilo-Smart Connect Module BT.
Depending on the inserted CIF module type, an associated settings menu is displayed in the
menu:
"Settings"
1. "External interfaces" displayed.
The respective settings are described in the display and in the CIF module documentation.
General settings are made under "Settings"
• Display brightness
• Country/language/units
Set brightness of the display
and status LEDs
.
• Bluetooth On/Off
(This setting item only appears if the Wilo-Smart Connect Module BT is plugged in.)
• Key lock ON
• Device information
• Pump kick
Under "Settings"
1. "Device settings"
2. "Display brightness"
NOTICE
The menu "Bluetooth setting" only appears in English.
, "Device settings".
en
207