Wilo -Stratos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 153

Fig. 18: Threaded cable glands/cable bush-
ings
Installation and operating instructions • Wilo-Stratos GIGA2.0-I, Wilo-Stratos GIGA2.0-D • Ed.02/2022-07
In order to feed more than one cable through the metal threaded cable gland (M20), two
multiple inserts for cable diameters of up to 2x 6 mm are included in the kit.
1. Screw in threaded cable glands as required. Observe the tightening torque. See "Elec-
tronic module tightening torques" [} 160] table in the "Turning the display" [} 160]
section.
2. Make sure that a gasket is fitted between the threaded cable gland and the cable
bushing.
The combination of threaded cable gland and cable bushing must be made according to the
following "Cable connections" table:
Connection
Electrical mains connection
3~380 V AC ...
3~440 V AC
SSM
1~220 V AC ...
1~240 V AC
12 V DC
SBM
1~220 V AC ...
1~240 V AC
12 V DC
Digital input EXT. OFF
(24 V DC)
Digital input EXT. MAX/EXT.
MIN
(24 V DC)
Bus Wilo Net
(Bus communication)
Analogue input 1
0 ... 10 V, 2 ... 10 V,
0 ... 20 mA, 4 ... 20 mA
Analogue input 2
0 ... 10 V, 2 ... 10 V,
0 ... 20 mA, 4 ... 20 mA
Analogue input 3
PT1000
0 ... 10 V, 2 ... 10 V,
0 ... 20 mA, 4 ... 20 mA
Analogue input 4
PT1000
0 ... 10 V, 2 ... 10 V,
0 ... 20 mA, 4 ... 20 mA
CIF module
(Bus communication)
Threaded cable gland
Plastic
Plastic
Plastic
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
Metal with shielding
en
Cable Terminal
bushing no.
Fig. 18,
Item
1 1 (Fig. 19)
2 2 (Fig. 19)
3 3 (Fig. 19)
4, 5, 6 11 ... 14
(Fig. 20)
(DI1 or DI2)
4, 5, 6 11 ... 14
(Fig. 20)
(DI1 or DI2)
4, 5, 6 15 ... 17
(Fig. 20)
4, 5, 6 1, 2, 3
(Fig. 20)
4, 5, 6 4, 5
(Fig. 20)
4, 5, 6 6, 7, 8
(Fig. 20)
4, 5, 6 9, 10
(Fig. 20)
4, 5, 6 4 (Fig. 25)
153